Startechcom SAT2510BU2 User Manual download pdf (Page 6)

Instruction Manual

5. Re-fasten the screws that were removed in step 2.

How to Use

Connecting the Hard Drive

Once the enclosure has been attached to a computer, and the necessary software has

been installed, the drive will be accessible as though it were installed within the system.

Prior to using the drive, it will need to be formatted according to your operating

system requirements. To format your newly attached hard drive, or create partitions,

please consult the documentation that accompanied your operating system at the

time of purchase.

Powering the Drive Enclosure

The hard drive enclosure requires no external power supply,

as it is capable of receiving enough power (5V/500mA) from

the USB Bus to which it is connected.

NOTE: Only the Primary connector is required to be plugged

into the computer system. The Secondary connector may be

required if the hard drive cannot draw enough power from a

single USB port.

LED Indicator

The hard drive enclosure oers an LED indicator, to enable you to monitor drive

activity. When the enclosure is powered, the LED will illuminate and remain green.

While the hard drive is being accessed, however, the LED will change from green to

red. Do not remove the enclosure from the host computer while the LED is red, as it

could damage the drive or the enclosure, resulting in data loss.

1 2 3 4 5 6 7 8 9 10

No comments

Startechcom SAT2510BU2 User Manual Page 6